%
O100(UBURR PROGRAMMING)

N1T100 (CHAMF UBBER)
M25(COOLING)
M8(C AXIS ON)
G98 (SPECIFIES FEEDRATE PER MINUTE)
G28H0 (C AXIS ZERO)
G0C0.(C AXIS POSITION)
G0Z-2.T1
G1Z-0.1F100

#101=2.0(TOOL LOCATION START)
#102=2000(S-CUTTING SPEED, ACCORDING TO CUTTING RECOMMENDATIONS)
#103=25.4(H1-PILOT HOLE LENGTH)
#104=4.0(LTB1, ACCORDING TO ITEM TABLE LIST)
#105=12.0(LTB2, ACCORDING TO ITEM TABLE LIST)
#106=2000(RAPID LINEAR FEED FOR POSITION THE TOOL)
#107=200(WORKING CYCLE FEED, ACCORDING TO CUTTING RECOMMENDATIONS)

M36S#102(SPINDEL SPEED ON)
G0Z[#101](START POSITION)
G1Z[#104]F#107(LTB1)
G04U0.5(PAUSE FOR 0.5 SECONDS)
G1Z[#104+3.0]F#107(LTB1+3mm)
G1Z[#103+#105]F#107(H1+LTB2)
G04U0.5(PAUSE FOR 0.5 SECONDS)
G1Z[#105-3.0]F#107(LTB2-3mm)
G1Z[#101]F#106(EXIT FROM THE PILOT HOLE)
G0Z-5.0
M38(SPINDEL SPEED OFF)
M9(C AXIS OFF)
G0T0(OFFSET CANCELLATION)
G99(SPECIFIES FEEDRATE PER REVOLUTION)

M99
%