%
O100(UBURR PROGRAMMING)

T1M6 (CHAMF UBBER)
M08(COOLING)
G90G54G00G40G80G17G98
G43H1X0.0Y0.Z50.0
G0 X0.0 Y0.0(STARTING POINTS X/Y)
G0Z25.0(STARTING POINTS Z)
G98(SPECIFIES FEEDRATE PER MINUTE)

#101=2.0(TOOL LOCATION START)
#102=2000(S-CUTTING SPEED, ACCORDING TO CUTTING RECOMMENDATIONS)
#103=25.4(H1-PILOT HOLE LENGTH)
#105=12.0(LTB2, ACCORDING TO ITEM TABLE LIST)
#106=2000(RAPID LINEAR FEED FOR POSITION THE TOOL)
#107=200(WORKING CYCLE FEED, ACCORDING TO CUTTING RECOMMENDATIONS)

M3S#102(SPINDEL SPEED ON)
G0Z[#101](START POSITION)
G1Z-[#103+#105]F#107(H1+LTB2)
G04U0.5(PAUSE FOR 0.5 SECONDS)
G1Z-[#105-3.0]F#107(LTB2-3mm)
G1Z#101F#106(EXIT FROM THE PILOT HOLE)
G0Z5.0
M5(SPINDEL SPEED OFF)

G91G28Z0M9(HOME POSITION Z)
G28X0Y0(HOME POSITION X/Y)
G90(ABSOLUTE POSITIONING SYSTEM)
M1(OPTIONAL STOP)
M5(SPINDEL STOP)
G99(SPECIFIES FEEDRATE PER REVOLUTION)

M30
%